Braindump: Moving clustered VMs from one Hyper-V cluster to another

This applies to Server 2012 and newer, but these directions are from when I moved VMs from a 2012 cluster to a 2012 R2 cluster.

  1. On the new cluster, right-click on the cluster and choose More Actions -> Copy Cluster Roles
  2. Choose the roles to copy, and then complete the wizard. This will set up the roles and their dependencies on the destination cluster.
  3. Shut down the VMs on the source cluster
  4. Take the relevant storage offline in Failover Cluster Manager (FCM)
  5. Disconnect the iSCSI volumes on all source cluster nodes
  6. Re-assign the LUNs to the new cluster nodes in your SAN of choice’s management console
  7. Connect the LUNs on the destination cluster nodes, but leave the disks offline in disk management
  8. In FCM, go to storage and bring the copied disks online. You should see the volume details reflected in the bottom details pane if all is successful.
  9. Start the VMs

Some good Hyper-V and Failover Cluster tips on TechNet

I’ve been browsing the Hyper-V related articles on TechNet while planning to move over to a failover cluster, and have found some useful tips. The TechNet articles are a literal goldmine of information if you can be bothered reading through it all.

They answer some of the initial questions I had when first implementing Hyper-V

If you change the configuration of a virtual machine, we recommend that you use the Failover Cluster Manager snap-in to access the virtual machine settings. When you do this, the cluster is updated automatically with the configuration changes. However, if you make changes to the virtual machine settings from the Hyper-V Manager snap-in, you must update the cluster manually after you make the changes. If the configuration is not refreshed after networking or storage changes are made, a subsequent failover may not succeed or may succeed but result in the virtual machine being configured incorrectly. original here…

For iSCSI: If you are using iSCSI, each clustered server must have one or more network adapters or host bus adapters that are dedicated to the cluster storage. The network that you use for iSCSI cannot be used for network communication. In all clustered servers, the network adapters that you use to connect to the iSCSI storage target should be identical, and we recommend that you use Gigabit Ethernet or a faster network adapter. original here…

You cannot use teamed network adapters, because they are not supported with iSCSI. original here…

On a failover cluster that uses Cluster Shared Volumes, multiple clustered virtual machines that are distributed across multiple cluster nodes can all access their Virtual Hard Disk (VHD) files at the same time, even if the VHD files are on a single disk (LUN) in the storage. original here…

Software requirements for using Hyper-V and Failover Clustering: All the servers should have the same software updates (patches) and service packs. original here…